November 20, 2026 · Bill · Rotor Rate · Reviewed November 2, 2026
Why Every Part 107 Pilot Should Log the Jobs They Pass On
Every job you turn down tells you something about the market. Here's how logging your passes shows which networks lowball you, and how many miles and hours you kept by saying no.
Every pilot has a story about the one they walked away from. The $120 real-estate shoot an hour out. The roof inspection that wanted a thermal camera you don't own. The mapping job priced so low the gas alone would've eaten it.
What most of us don't have is a record of why we said no. And that record, stacked up over a few months, turns out to be one of the more useful things a small drone business can own.
Memory is a lousy database
When you pass on a job, the reason feels obvious. Too far. Too cheap. Wrong gear. Bad timing. Three months later, the same network sends you something similar and you've got nothing but a vague feeling that "they're usually low."
Networks like Droners.io, FlyGuys, RAAD and Zeitview send a steady stream of offers. Most of us treat them like inbox noise: read, decide, delete. Treat them as data instead (network, rate, distance, deliverable, reason) and patterns show up that no single job could show you.
Why we pass
If you've flown commercially for a few months, you've probably used most of these:
- Rate too low. Below your floor before you even count mileage and time.
- Too far. The drive makes your effective hourly rate (what you actually earn per hour once drive time counts) fall apart.
- Bad timing. Schedule conflict, weather window, or a same-day deadline.
- Wrong job type. Thermal, mapping or cinematic work that doesn't fit your kit or skill set.
- Equipment. A sensor or platform you don't carry.
- Something else. Client red flags, permit headaches, a gut feeling.
One pass is a judgment call. Fifty passes, dated and sorted, is a map of your market.
Three passes from my own log
Here are three real offers from my Pass Log, all roof inspections from insurance-inspection networks, all from the same week.
I'm keeping two numbers apart on purpose, because mixing them is how pilots fool themselves:
- Cash in pocket is the offer minus what you actually spend to do the job. For these examples that's fuel, figured at about 22¢ a mile (my FJ Cruiser averages 17.8 miles per gallon, and regular was $3.89 when I wrote this). Plug in your own vehicle.
- Mileage deduction is what you get to write off at tax time, using the IRS rate for the offer date (76¢ a mile since July 1, 2026). It lowers your tax bill. It is not money you spent, so it doesn't get subtracted from your profit.
The $45 "quick" inspection
- Offer: $45 flat
- Drive: 68 miles round trip, about 1.6 hours
- On site: 1 hour
- Total time: about 2.6 hours
- Fuel: about $15
- Cash in pocket: $30, or about $12 an hour
- Mileage deduction at tax time: $51.68
Twelve bucks an hour, before the photos, the upload, insurance, or the risk to the aircraft. And those 68 miles still put wear on the truck that you'll pay for later. Easy pass.
The $75 "reasonable" one
- Offer: $75 flat
- Drive: 34 miles round trip, about 1.2 hours
- On site: 1 hour
- Total time: about 2.2 hours
- Fuel: about $7
- Cash in pocket: $68, or about $31 an hour
- Mileage deduction at tax time: $25.84
The best inspection offer of the week. Thirty-one an hour sounds okay until you take out self-employment tax (15.3%), insurance, batteries and the rest of the overhead. Close by isn't the same as worth it.
The half-day windshield job
- Offer: $90 flat
- Drive: 264 miles round trip, about 4.8 hours
- On site: 2 hours
- Total time: about 6.8 hours
- Fuel: about $58
- Cash in pocket: $32, or about $5 an hour
- Mileage deduction at tax time: $200.64
Most of a work day for five dollars an hour, plus 264 miles of tires and oil changes. Offers like this get sent across a wide radius, so somebody somewhere will look at the top-line number and say yes. Don't let it be you.
None of these needed a spreadsheet to spot. But logging them is what turns "insurance work feels cheap" into "insurance work in my area pays about minimum wage once you count the drive." That's a number you can plan around.
The bigger picture: averages by platform type
One bad offer is an anecdote. Seventy of them is a pattern. Once my log passed 70 entries, I grouped the offers by the kind of platform that sent them and averaged everything out. "Hours" means drive time plus time on site. Cash $/hr takes out fuel (22¢ a mile) and any platform fee. The deduction column is the tax write-off for that average drive at 76¢ a mile, shown separately because it isn't spending.
| Platform type | Passes logged | Avg offer | Avg round trip | Avg hours | Gross $/hr | Cash $/hr | Mileage deduction per job |
|---|---|---|---|---|---|---|---|
| National asset broker | 46 | $150 | 368 mi | 5.6 | $27 | $12 | $280 |
| Roof inspection app | 4 | $119 | 250 mi | 6.8 | $17 | $9 | $190 |
| Bidding portal (10% fee) | 14 | $200 | 155 mi | 4.2 | $48 | $35 | $118 |
| Managed enterprise network | 5 | $497 | 445 mi | 9.7 | $51 | $41 | $338 |
A few things jump out:
- The offer price isn't the whole problem. The drive is. The broker offers looked like $27 an hour on paper. After fuel, the average job paid about $12 an hour, and that's before overhead or the wear on your vehicle.
- Long drives cost you twice. Once in hours you can't bill, and again in wear and tear. The deduction column is a decent gut check on how much vehicle you burned up. A $280 write-off on a $150 job means a lot of miles for not much money.
- These are passes, not every offer. This table only shows jobs I turned down, so it's tilted toward the bad ones. That's the point: it shows where the bad ones come from.
None of this means a platform is good or bad. It means the same network can send you a great job and a money-losing one in the same week, and the log is how you tell them apart. Rotor Rate's Pass Log builds this table for you as you go.
Passing isn't losing
Here's the part that bugged our buddy Eric, and it bugged me too. A job you bid on and didn't get is a loss. A job you looked at and declined is not. Lump them together and your win rate looks worse than it really is, and you can't tell whether you're pricing badly or just turning down junk.
So in Rotor Rate, the two stay separate. Every subscriber has access to the Pass Log. Hit Archive as pass on either calculator, or mark a saved job Passed (I declined) in your Workspace, and it goes to your log instead of counting against you.
What's worth writing down
At minimum, each pass should have:
- Network. Who sent it.
- Offered rate. The gross number before your costs.
- Location and drive distance. So you can see where your geographic line really sits.
- Date. When it was offered.
- Job type. Photo, inspection, mapping, video.
- Why you passed. One or more of the reasons above.
Rotor Rate also grabs the drive time, hours on site and editing time from the calculator when you archive, so it can grade the offer against your fair rate later without you re-typing anything.
The Network scorecard
Once you've got a handful of passes in there, the Pass Log builds a Network scorecard for you. For each network it shows:
- Delta from fair. A color-coded look at how the offer stacks up (red for way under, amber for thin margins, green for right at fair).
- Median $/hr. What you'd have really earned per hour, counting the drive.
Below that, it adds up what saying no kept in your pocket:
- Miles not driven.
- Mileage you didn't have to put on the vehicle, shown at the IRS rate for each offer's date.
- Hours kept. Drive, on-site and editing time you got back.
IRS standard mileage rate (2026): $0.760/mi (76¢ per mile; for the year: 72.5¢/mi January–June and 76¢/mi from July 1) for business use of a personal vehicle. Multiply your business miles by this rate to get your deductible vehicle expense — no separate fuel, maintenance, or depreciation receipts required when you use the standard rate. Verify the current year's rate at IRS — Standard Mileage Rates before filing. Rotor Rate updates this rate when the IRS publishes a change and values each trip at the rate in effect on its date.
A note on that vehicle number. It's your mileage deduction, the amount you'd get to write off at tax time for those miles. It's not cash you saved at the pump, and it isn't part of your profit math. Think of it as a measure of how much driving you skipped. Check your own tax situation with a tax pro.
Some networks will float to the top of that list as the ones that consistently lowball you. That's not a hunch anymore. It's your own numbers.
When a job comes back at a higher rate
Networks sometimes re-post a job at a higher number after the first round of pilots passes. Log the bump. If it clears your fair rate, one tap on Accept moves it to Awarded in your Workspace so you can schedule it. If a job gets re-posted three times and still isn't worth it, that tells you something about the network, too.
Start today
You don't need software to begin. A spreadsheet with the fields above works fine. After a month, sort by network and look at the middle offer. Sort by distance and see where your line is.
When you're tired of babysitting a spreadsheet, the Pass Log in the pricing calculator handles the math and history for you, using the same numbers that power your quotes. And if you haven't set your floor yet, the Hourly Rate Builder is the place to start. Everything else gets measured against it.
---
Sources & further reading
- Standard Mileage Rates. Internal Revenue Service. 2026. https://www.irs.gov/tax-professionals/standard-mileage-rates. Accessed September 2026.
- Drone Pilot Networks Compared — Rotor Rate guide to network fees, payment terms and rate expectations.
- Hourly vs. Flat-Rate Pricing for Drone Services — How to build a loaded hourly cost.
- Drive Time, Mileage & Margin — Why distance costs more than it looks.
Until next time.
Bill
Related guides
Go deeper on the rest of the drone-pricing topic — same framework, different angle.
Swipe for 4 links →
How to Price Drone Services
The eight factors and bid formula behind every defensible quote.
Drone Photography Pricing hub
Real-estate, brand, and event photo rate ranges with the math behind each.
Drone Mapping Pricing hub
Per-acre rates, processing time, and how to tier large-area jobs.
Drone Inspection Pricing hub
Tower, roof, solar, and infrastructure inspection rate ranges.
Next steps
What to do once you have a number you trust.
Swipe for 2 links →